Funny, Strange, Random Pics

  • Guest, it's time once again for the massively important and exciting FoH Asshat Tournament!



    Go here and give us your nominations!
    Who's been the biggest Asshat in the last year? Give us your worst ones!

Muurloen

Pronouns: zie/zhem/zer
13,894
39,505
amazing...

rrr_img_23527.jpg


rrr_img_23527.jpg
 

Borzak

Bronze Baron of the Realm
25,556
33,361
I did draw this once, a water slide in Baton Rouge.

Water_Slide-Blue_Bayou_Water_Park-3000000022328-500x375.jpg




Go ahead and laugh at my square, it was exciting to me. The next best option to get that clean of a cut is a waterjet that takes 1.5 hours to pierce and cuts at less than 1" per hour
smile.png


I did the design and detail of the walk way out to the casino riverboat (Belle of Baton Rouge), and so far nobody has fallen to their death (that I know of, dunno about drunks tho).

7169977.jpg


I did do one of these once and a guy fell off while erecting it and died and I wound up giving depositions for a few years.

stack_testers_600.jpg


Water_Slide-Blue_Bayou_Water_Park-3000000022328-500x375.jpg


smile.png


7169977.jpg


stack_testers_600.jpg
 

Dookiefart

Silver Knight of the Realm
184
36
Not really, I sit inside in my office for most of it and the guy outside does all the mans work by putting the plate on the burner and taking it off. It's a plasma burner with an oxy head as well. It has a side lathe that will cope pipe up to 24" for pipe saddles and multi part elbows etc...that piece was cut with the oxy torch with no preheat. I thought it was pretty impressive and I've been doing this stuff for about 20 years.

It's all pretty new to me. I'm really a draftsman and structural steel designer but I'm helping out the company I just went to work for get set up since nobody else knew anything about it.

All next week I'm pretty sure I am going to be doing name plates, BBQ pits with names in them, and other artwork for mailboxes and stuff.

Next week I'm flying to Chicago to look at a piece of equipment that will cut a beam up to 30" deep, and then burn the holes and copes with a laser.

Similar layout as this punch one.

beam_line.jpg
Please keep me up to date... Apparently these dickheads have never had to cut 1" plate with a oxy acetylene torch.. Tech like this is fucking amazing